How To Use The Power Out On The Family Easy Board Using 1 Main Power Switch

This how too is for this product: Pandora Box Family Easy Install Board



To connect the main power switch to the connect easy connect board you will need the following items:
Dual 2 Pin JST
5.5mm x 2.1mm Male DC Plug to JST2 Quick Connection
3 Way Splitter (assuming you are using a 2 way at this time)
3 Foot Extension

- Unplug the 2 pin blue/white JST connector for the Main-PW-SW position
- Unplug the gold terminals from the main power switch
- Hook the dual 2 pin JST to the main power switch terminals via the gold connectors
.- Plug in one of the 2 pin JST back into the slot labeled Main-PW-SW

- Plug the other 2 pin JST into the connection on the easy board labeled 12V-Accessory-Switch
- Plug the 5.5mm x 2.1mm Male DC Plug to JST2 Quick Connection into the 12V-Out-1
- Remove the 2 way splitter and swap with the 3 way splitter
- Hook back up what was removed from the 2 Way Splitter
- Run the extra leg off the splitter to the Easy Board and plug into the port labeled 12V-ACC-Power. Whatever you plug in here is what power output will be at the 12v-out-1 port.
- Hook what ever you want to the 5.5mm x 2.1mm Male DC Plug to JST2 Quick Connection male. If you need more then 1 item powered off it re use the 2 way splitter you removed.



***Factory A1U Marquee "typically" require the below parts to plug into a standard 5.5x2.1mm connection







- 5.5mm x 2.1mm Male Plug to 3.5mm x 1.35mm Female Jack Converter
- 5.5mm x 2.1mm Female to Female DC Power Connector Adapter

Contact Us

Not finding what you're looking for? Contact Us Directly